Location: Mayville,WI, USA
JOB SUMMARY:
Set up, operate, and tear down a variety of punch presses to perform punching, drawing, and forming operations on all types of material to the required tolerances, as well as set up and operate coil feed equipment and CNC turret presses with minimal training.
ESSENTIAL FUNCTIONS:
Read and understand blueprints and routings and produce parts from the information obtained to the required tolerances.
Responsible for the quality of the parts produced and performed first-piece inspections and subsequent inspections to ensure overall quality.
Responsible for the care of routine maintenance and keeping the work area neat and clean.
Follow all rules regarding machine operation and machine guarding.
Maintain simple reports on productivity, quality, and safety.
Work ExperienceQUALIFICATIONS:
Possess and be able to use machinist squares, dial calipers, and other inspection equipment to ensure the quality of the parts being produced.
Must be equipped with all the required tools to perform the functions of their job.*
Physical ability to do work requiring frequent standing and bending, as well as pushing, pulling, and lifting up to 30 lbs. frequently.
Sufficient reading and writing ability to follow work order instructions and prepare simple production reports.
Sufficient visual acuity (corrected) to read instructions, operate machines, and inspect parts.
Sufficient manual dexterity to operate the equipment properly.
PUNCH PRESS AND BRAKE DEPARTMENT REQUIRED TOOLING LIST:
Per Article X, section K” of the contract these tools must be acquired within the prescribed period in order for the employee to be classified:
Allen Wrench Set, (1/16 – 1⁄2 inch sizes)
Machinist Square, (12 or 24 inch)
Tape measure, (12 foot)
Calipers, 8-inch minimum (Dial or Digital)
Center Punch
Scriber
Ball Peen Hammer
15/16-inch Combination Wrench, (Punch Press only)
Protractor, (Press Brake only)
Large Screw Driver, (Press Brake only)
Tool Box for the above tools.
This is a direct hire position.