Quality Inspector - Southern Motion Plant 3
: Job Details :

Description JOB DUTIES AND RESPONSIBILITIES:

• Quality Inspectors must learn to read daily schedule and accurately identify various styles listed.
• Visual inspection for cosmetic appearance and uniformity must be performed for each piece to include the following:

• Fabric must be free of flaws and any defects.
• Fabric must be the same shade and uniformity on backs, arms, seats and ottomans.
• Wing to arm ratio must be checked and be equal on both the left and right sides.
• Outside backs must be checked to assure that there are no unacceptable gaps at back side.
• Welt, gathers, seams and two-needle must be straight, level and uniform.
• Must check outside arms and backs for protruding staples and remove them if applicable.
• Check shipping label & schedule to verify that style number, cover number and thread color number are all correct.
• Inspector completes daily quality defect sheet - Identify type of defect and location of defect.

• Quality Inspectors must sit in every seat and check for following:

• Check hardware for proper operation - TV and full recline positions, etc.
• Test each motor through its full cycle to verify that it works properly.
• Makes sure all massage motors operate properly to include each cycle and setting.
• While in full recline inspector must check to make sure no raw frame or fabric shows.
• Check pitch to verify that it is correct.
• Check drop down table tops and console lids for proper installation and operation.
• Check for console cup holder color and proper installation.

• Back Quality Check:

• Make sure the backs are in alignment with the seats.
• See that backs are aligned both horizontal and vertical.
• Check to see that backs are filled, padded and applied uniformly from side to side and top to bottom.
• Verify that backs are all the same height.
• Makes sure that there are no unacceptable gaps in backs.
• Tie off strings must be pulled at the same depth in all backs, seats and arms.

• Seat quality check:

• Make sure seats line up horizontally and vertically.
• Seats must be filled properly with all corners filled out.
• Check for seat comfort, compression and feel - must be uniform in all seats.
• Verify that seats have no visible gaps, from seat to seat and from seat to ottoman.

• Arm quality check:

• Arms must be properly padded and consistent from left to right side.
• Arms must be filled and regulated properly and according to accepted standards.
• Arms must be applied uniformly from left to right.
• Pleats on stumps in one arm must be a mirrored image of the other.

• Ottoman quality check:

• Ottomans must be properly filled and consistent from left, center & right.
• Must line up from left to right, top to bottom - no drooping corners, etc.
• There must be no noticeable gaps between ottomans.

• Inspector must apply the appropriate hang tags.
• Shipping label to track quality and manufacturing process is applied by the inspector.
• Maintain clean and organized work station.
• Assist others when necessary.
• Perform any other duties as assigned.

RequirementsEDUCATION AND SKILLS REQUIRED

• Basic reading and writing skills required.
• Ability to read, understand and communicate the English language.
• Must be able to correctly identify colors.

SAFETY

• Personal Protection Equipment should be worn at all times within the department as well as throughout the plant where designated.
• Safety is enforced each day to prevent any accidents.